- banner runs After=spinifex.target so services are settled before banner writes
- switch systemctl restart → try-restart (safe if target not yet active)
- append banner to /etc/motd with sentinel instead of overwriting, preserving
the Debian disclaimer; sentinel ensures re-runs replace cleanly
- remove /etc/issue write — getty shows it pre-login which is wrong
- add getty@.service.d drop-in so all getty instances wait for banner before
showing login prompt; prevents service messages scrolling during login
- fix Makefile to prefer locally built spx/installer binaries over system PATH
- add `spx admin banner --boot-check` subcommand to spx CLI
- reads management IP from the NIC at runtime (not from node.conf)
- if IP has changed, updates /etc/spinifex/node.conf and restarts spinifex.target
- writes banner to /etc/issue (pre-login console) and /etc/motd (SSH MOTD)
- banner instructs user to cat ~/.aws/credentials (standard AWS CLI location)
- update firstboot.go to use spx-based banner unit; remove writeBannerScript
and old spinifex-banner.sh entirely
- new banner unit runs Before=spinifex.target so IP is current before services start
- chown /etc/spinifex and /var/lib/spinifex to spinifex:spinifex after
spx admin init so services running as the spinifex user can read configs
- add Environment=HOME=/root to firstboot unit to suppress $HOME warning
- increase wait-for-nats.sh timeout from 30s to 90s for slow startup
- banner now writes to both /dev/tty1 and /etc/motd (visible over SSH)
- add systemd.show_status=1 to GRUB cmdline for per-service boot feedback
- add --removable to grub-install EFI so fallback path EFI/BOOT/BOOTX64.EFI
is written (required for UTM and bare metal without NVRAM boot entries)
- add root password screen and manual NIC entry to installer TUI
- tee spx admin init output to /root/spinifex-credentials.txt with 0600 perms
Replaces charmbracelet/huh with a custom bubbletea wizard for the
installer TUI. This gives full control over terminal I/O so the
installer attaches directly to the correct console device (ttyS0 for
serial, tty1 for VGA) as directed by the new spinifex-init boot script.
- branding/branding.go: centralised logo (ASCII placeholder), color
constants, and publisher string ready for Mulga asset swap
- ui/ui.go: multi-screen bubbletea model (welcome → disk → network →
identity → join → CA cert → confirm) styled with lipgloss
- main.go: reads SPINIFEX_CONSOLE from /proc/cmdline to open the right
tty before launching tea.Program
- go.mod: bubbletea/lipgloss/bubbles promoted to direct deps; huh removed
Adds cmd/installer with three packages:
- ui: huh-based TUI collecting disk, network, node, and cluster config
- install: sequential install steps (partition, debootstrap, chroot, bootloader)
- firstboot: oneshot systemd service that runs setup-ovn and spx admin init/join on first real boot
Supports both single-node init and multi-node join flows.
Access key and secret key values were printed to stdout when using
--access-key and --secret-key flags. These are captured by systemd
journal and log aggregation, exposing secrets. Log that keys were
overridden without printing the actual values.
Addresses H-5 from security audit.
tomnewton-mulga