spx admin init now works with zero external networking flags:
- Auto-detects WAN interface, gateway, prefix from ip route
- Auto-detects single-NIC vs multi-NIC mode
- Defaults to nat mode with DHCP for gateway IP
- Prints detected topology with interface roles
setup-ovn.sh gains --dhcp flag: obtains a DHCP lease on the
macvlan/bridge interface for the OVN gateway SNAT address, then
writes gateway_ip into spinifex.toml. Tested on VM: macvlan gets
separate IP from router DHCP, host keeps its original IP.
Three tiers of external networking:
- Zero flags: auto nat+DHCP (VMs get outbound internet)
- --external-pool=start-end: pool mode (VMs get public IPs)
- --no-external: overlay only (no internet for VMs)
Add --single-nic flag to setup-ovn.sh. When used with --external-bridge,
creates a macvlan sub-interface (spx-ext-{iface}) in bridge mode off the
host's NIC instead of adding the NIC directly to br-external. The host
keeps its IP — no migration, SSH-safe.
Strategy selection:
- Dedicated NIC: --external-iface=eth1 (add directly)
- Single NIC: --external-iface=eth0 --single-nic (macvlan)
- IP migration: --external-iface=eth0 (legacy, no --single-nic)
Add single_nic bool field to VPCDConfig for per-node config. Different
nodes in a cluster can use different strategies. Unit test verifies
single_nic parsing alongside external_interface.
Add external IPAM module (CAS-based IP allocation from admin-defined
pools in NATS KV). Supports multi-pool with region/AZ scoping, pool
fallback logic, gateway IP reservation, and concurrent allocation via
CAS retries. 12 unit tests covering allocation, release, exhaustion,
CAS conflict, multi-pool, fallback, validation, and idempotent init.
Add --external-bridge flag to setup-ovn.sh: creates OVS bridge
br-external, adds WAN NIC, migrates host IP to bridge, and sets
ovn-bridge-mappings=external:br-external for OVN localnet ports.
Add commented [network] section and external_interface to spinifex.toml
config template for discoverability.
Redistribute E2E tests between single-node and multi-node suites, slim
down pseudo multi-node suite, and remove directory creation from
dev-setup.sh so spx admin init is the single source of truth for
~/spinifex/ setup.
The MIN_LOC=100 threshold checked total diff lines, not instrumentable
lines. A commit with many non-instrumentable lines (structs, comments)
but only 1-2 instrumentable lines would unfairly fail at 0% coverage.
Add a minimum instrumentable lines threshold (5) so the check skips
when the sample size is too small to be meaningful.
Extract duplicated respondWithError closures into a single package-level
function. Guard against nil ImageId in handleEC2RunInstances to prevent
panic under race conditions. Fix diff-coverage base ref for main branch.
is_multinode() counted all [nodes.*] TOML subsections (daemon, nats, awsgw,
etc.) instead of just top-level node entries. A single-node config has ~8
such sections, causing the single-node Docker E2E to use coordinated cluster
shutdown and exit with code 254.
Fix grep to match only [nodes.X] (not [nodes.X.Y]) and preserve the original
test exit code in the cleanup trap.
Ben Duncan